Amazing Casting Products: Moldmaking Like a PRO... DIY iPhone and GoPro Cases Part 2 by Lonnie Sexton

This project has two parts for the same purpose. I needed standard camera stand mount cases for my iPhone and GoPro cameras. Not that I don’t like the stock GoPro case, but I just needed a simple easy access case to use in the shop that connects to a 1/4-20 Stand. Below are the steps to create a custom case using Amazing Crafting Products.

This is part two of a two part post – iPhone is featured in part one.

Please CLICK HERE to jump over to view part one.

Parts/Tools:

Amazing Mold Rubber
Amazing Casting Resin
Mixing Cup
Mixing Stick
Mold Release
Alumilite Dyes - Red and Fluorescent "FLO" Orange
Modeling Clay - gray
Poster Board
Cell Foam
Foam Safe Glue
Accelerator
Hot Glue Gun
Box Knife (razor for cutting poster board)
Xacto Knife
Ruler
Sharpie

Steps:

Create Primary Object – Custom iPhone & GoPro camera mount cases
Mold the Primary
Demold
Casting
Final

PRIMARY

I used Cell Foam to create the prototype version. Parts of this project can also be found in part one. It’s easy to cut, shape and glue. Cell foam is porous and flimsy, but works for quick parts. However, there is a downfall. Unless you go through a coat and sanding process, the finished product will be rough on the edges where the cell foam is porous.

Outline the iPhone and GoPro on the cell foam sheets x2.

Using foam safe glue, assemble the parts for a custom fit.

Rubber Mold

Prepare the part for a 2-part mold using modeling clay.

Using hot glue and poster board, create a mold box around the part.

Mix and pour the Amazing Mold Rubber per instructions {CLICK HERE
to view mixing/preparation}. Cover the part completely and let cure.

Demold and Mold Part 2

Once the Amazing Mold Rubber is cured, remove the clay.

Assemble the mold box around the rubber mold apply mold release per instructions.

Prepare another batch of Amazing Mold Rubber to pour the

second half of the mold and let cure. This will create an insert.

Remove the 2 part rubber mold. Separate the insert and primary from the mold.

Carefully slice the first rubber mold in half creating 3 parts.

Using 2 sides from the mold box, secure the 2 parts together

with rubber bands. The mold is now ready for casting.

Casting

Mix Amazing Casting Resin per instructions {CLICK HERE to view mixing/preparation}. Add Alumilite Dye {if desired} during the mixing process to Part "A" of the resin per instructions.